Petrainers 1000 метров водонепроницаемый дистанционный ошейник для собак Pet900 расширения

Multi-Dog Training System Wellturn 759 with Rechargeable and Waterproof Receiver Collar has been proven safe, comfortable, and effective for all pets over 25 pounds. This system assists you in controlling your pet without a leash in a range up to 1000m. At the push of a button, the Remote Transmitter sends a signal, activating the Collar Receiver and conducting the corrections. Using the Remote Trainer consistently and correctly, much of your dog's bad habites can be corrected.

2. How to use the remote transmitter

1. Press Mode Button for 5 seconds to trun on the transmitter.

2. Select the channels for receivers by switching the Knob on the transmitter.

3. Press M1 to select the memory group, then start setting correction modes with Mode

    Button.

4. Adjust the intensity levels for shock & vibration with the Up/Down buttons on right side.

5. Finally, press M2 to save the correction setting as a memory group, and there are

3 memory groups for each channel.

6. Press Launch Y button to send the correction signal as is set beforehand.

3. Charge the collar receiver:

1. Press the power button to turn on the Collar Receiver, the green LED light flashes every

    4 seconds after a beep.

2. Charge the Collar with adaptor that comes with the unit, and the red LED turns on

    during charging.

3. Dis-charge the collar when you see the red light turns off automatically.

Note:
Please check whether the battery needs to recharge before you use it. When you turn on the receiver, if it beeps for 20 seconds, it indicates it's in a low power state.

4. Connect transmitter and receiver:

1) Turn on the transmitter by pressing any button on the transmitter.

2) Switch the knob to choose channel for pairing, choose channel first receiver.

3) Restart the receiver with a beep sound.

4) After a beep from the receiver, press the “Y” button within 10 seconds.

5) The collar receiver beep again means they are connected successfully.

Note:

1. Lightly Standby : In order to save power, the Remote Transmitter will go into

    Standby Mode if there is no operation over 2 minutes, press any button can

    activate Remoter Transmitter lighting up the screen.

2. The transmitter turns into deep sleep mode for no operation over 5 minutes, you

    need to long press the mode button for 5 seconds to turn in on.

3: The collar receiver goes into deeply sleep for no operation over 5 minutes, any

    movement could activate the receiver.